Road, track, or trail, our Analog Motor Goods Ankor Device Mount is designed to hold your device secure throughout all conditions. Hover your device near the magnetic surface and it instantly locks securely in place. Designed to be quick, easy and convenient, the Ankor Device mount will work with 7/8”, 1” or 1-1/8” handlebars.
Note: We recommend using this mount with a hard device case; never use this product with an unprotected device. Analog Motor Goods is not responsible for damage that occurs to your device while using this product. See further instructions below.
Whether you are looking to mount a phone, GPS, camera or any other accessory, the Ankor Device Mount is guaranteed to be the most reliable & convenient accessory for your motorcycle. The unique and powerful iOmount magnetic component ensures a strong hold no matter the orientation of the device or vibration of the driving surface.
Special Installation Instructions for Ankor Device Mount:
The iOadapt™ disc must touch the iOcore™, it is not secure when used through a device case. For this reason, it must be installed on the exterior of your device case for complete contact. Note that the iOadapt™ uses a very permanent adhesive. Once it’s attached, it cannot be easily removed without damaging the case or device it has been attached to.
Where do I Install the Ankor Device Mount?
Ankor Device Mount must be installed on a flat section of bar. We recommend a minimum of 0.5” away from any bends or curves. Never install this product on a bend or curve, as it may seem stable upon initial installation, but will most likely become loose over time due to incomplete contact with the bar.
– Ankor Device Mount
– 2x iOadapt, disc to attach to your device
– iOcore, a magnetic cylinder that provides connection between the iOadapt and Ankor Device Mount