Motogadget m-Button

Motogadget m-Button

$ 56.00

Designed for use with the m-Unit, the Motogadget m-Button allows you to streamline the wiring from your controls and pare down your wiring to a single wire running to the m-Unit for all of your controls. This ends up being ideal for running switch wiring through into your handlebars and connecting it all via the m-Button. About the size of a thimble, the m-Button fits neatly into handlebars or wherever you need to tuck it to keep it out of sight. A must-have component for a virtually invisible wiring install.

If you’re looking for another Motogadget product that you’re unable to find listed here on our site, send us an email and we’ll be happy to special order any Motogadget components you need. Delivery time for special order products can vary, so please contact us with questions should your project be on a tight deadline.

Out of stock

Designed for use with the m-Unit, the Motogadget m-Button allows you to streamline the wiring from your controls and pare down your wiring to a single wire running to the m-Unit for all of your controls. This ends up being ideal for running switch wiring through into your handlebars and connecting it all via the m-Button. About the size of a thimble, the m-Button fits neatly into handlebars or wherever you need to tuck it to keep it out of sight. A must-have component for a virtually invisible wiring install.

From Motogadget, about the m-Button:

Another innovation from motogadget: the m-Button.
It’s a big help – in combination with the new m-Unit V.2 – in reducing ‘cable clutter’ and simplifying wiring harnesses.

Integrated into the handlebar tube – or any other adequate location – this tiny cylinder will electrically connect all handlebar instruments, switches and buttons.
Using state-of-the-art bus technology, the m-Button digitally processes signals and transmits them to the m-Unit V.2 over a thin cable.
The electrical consumers will then be switched inside the m-Unit.
All control wires are moved into the handlebar. This saves space, weight, labour and time. A ‘must have’ for custom bikes with clean-look handlebars.

In simple facts:
a) normally, the operating current (e.g. headlight or turn signals) is transmitted directly via the wiring of the handlebar switches. Due to the high currents, cables with large cross-sections have to be routed from the fuse box to the switch and back to the electrical consumer.
The result: big cable bundles. Definitely, a ‘no go’ for custom bikes with restricted space or a concealed electrical system.

b) using the m-Unit without the m-Button, just a thin cable for each switch- or button-controlled feature has to be routed to the m-Unit. These cables only carry minute control currents. All high loads and currents are switched directly at the m-Unit and transmitted directly to the electrical consumers. This already leads to a significant reduction and simplification of the wiring harness. Here you can see the example of a circuit diagram.

c) using the m-Unit V.2 in combination with the tiny m-Button, you will once again reduce the amount of cables that have to be routed! All switches/buttons on the handlebar are connected at the shortest distance possible and concealed inside the handlebar. Consequently, you will have to route only ONE thin cable from the m-Button to the m-Unit. All loads and currents will be switched directly at the m-Unit V.2 (see explanations above). A layout reduced to the max! Here you can see the example of a circuit diagram with use of m-Button.

Weight 0.4 lbs
Dimensions 12 × 5 × 1 in

Reviews

There are no reviews yet.

Add a review